Ventilation Accessories


STANDARD DUCTING WITH 8 3/8" "BELL" CUFF AND BUCKLE STANDARD ON BOTH ENDS


CONDUCTIVE DUCTING WITH GROUND WIRES ON EACH END OF HELIX
Maximum temperature rating 180 degree F


8" DUCT TO DUCT CONNECTOR
MODEL SVH-88C

Galvanized Steel or Polyethylene
Consult Customer Service for Additional Sizes

 


  MODEL SVF-8ALM
AUDIBLE & VISUAL ALARMS ACTIVATE WHEN LOW FLOW OCCURS WITHIN THE SYSTEM

STANDARD AND CONDUCTIVE VENTILATION DUCTING
· Vinyl polyester ventilation air duct hose
· 8" diameter with external wear strips
· Custom sizes available on request
· Internal steel reinforced wire hoop
· 6" long attachment cuff
· Maximum temperature rating 180 degree F



DUCT CARRIER
STANDARD POLYETHYLENE
MODEL SVH-DC25


· Snap lock lip on lid
· Carry handle
· Holds up to 50ft. of 
   8" diameter duct
· Eases duct storage
· Keeps duct from
   getting ripped

 

 

CUSTOM GALVANIZED DUCT CARRIER SIZES AVAILABLE UPON REQUEST

 

 

THE VENT FLOW
ALARM SYSTEM

DESIGNED SPECIFICALLY TO MEET THE NEW ONTARIO CONFINED SPACE REGULATION

Activates an audible and visual alarm when reduced or no flow occurs within the ventilation system.  Operates on twin 9-volt batteries and is NOT dependent on the blowers electrical supply.  Will attach to ANY 8" diameter ventilation duct.

Click to Print
print page

E-mail this Page

In-line Filter Holders

Ventilation Blowers

Axial Fans

Confined Space Ventilation On-line Training

 

 

 

 

 

 


Ventilation Heaters
                 

Electric In-Line

MODEL SVF-7KW-8
   
 27"L x 16"H x 15.5"W
  40 LBS 

  • Requires 230/1 VAC, 28amp       

  • Supplied with 30amp twist-lock plug

  • 8" inlet and exhaust fland

  • Aluminum start with blower running

  • Built-in safety pressure switch

  • Automatic thermal shutdown at 170 degrees F

  • 144 degrees F output at exhaust - 112 degrees with 15' duct

  • Order 3ft heater connect duct part no SVH-H70-3

  • 23,900 BTU

 


 


 

 

 

 

 

 

 

 

 

 


 

MODEL SVF-15KW-8
32"L x 27"H x 37.5"W
  95 LBS 

ELECTRIC IN-LINE HEATER
15kw, 440/3, 26AMP
51,216 BTU

 

 

Propane Heater

  • 70,000 BTU output

  • Uses standard propane fuel tank (regulator and tank sold separately)

  • Requires 110 VAC for electronic ignition single phase

  • 15 watts power consumption

  • Weight: 20 lbs.

  • Steel construction

  • Built-in safety devices for flame detection, temperature control, and loss of air flow

  • Designed to fit SVF series fans and other Air Systems blowers

  • CGA approved

  • 1.5 amp fuse protected

     


Back to top

IN-LINE FILTER HOLDERS
USE FOR ODOR AND DUST REMOVAL



  
     

                  MODEL FH24-8
 

  • Holds a 24" x 24" x 2" filter

  • 8" duct flange on one end

  • Allows user to filter intake or discharge air

  • Available in stainless steel or aluminum

  • Custom sizes and designs available
     

GALVANIZED STEEL IN-LINE HEPA FILTER

24" X 24" X 11 1/2"

HOLDS ADDITIONAL 2" PLEATED PRE-FILTER FOR DUST AND ODORS

 

 

MODEL FH24-8-14


Back to top